I have Test instances for v10 & v11 side-by-side on the same box. I also have Test Transcend on the same box which always worked fine with v10. Now the Transcend ascii gateway in the Transcend control tray will not start. I suspect this is a port conflict since I installed v11 services on this box. Does this sound right? I don’t recall setting any port# during the v11 setup. Can I share transcend while testing v10 & v11?
You should be able to share your one Test Transcend between your v10 and v11 Test systems, and they should all be ok on the same box. The v11 install shouldn’t impact Transcend’s ascii gateway unless you happened to set a v11 port to the same as Transcend is listening on. The first suspect would be the payment gateway service. Check it’s config file and verify that the ‘transcendPort’ value in the <Transcend> node is set to the port that the Ascii Gateway is listening on. Also check that the ‘Port’ value in the <appSettings> section is set to the port the payment gateway Windows service is listening on (this should match what is in t_defaults).
From: Tessitura Next Generation Forum [mailto:forums-nextgeneration@tessituranetwork.com] On Behalf Of David VivinoSent: Tuesday, August 07, 2012 9:47 AMTo: Ron WilsonSubject: [Tessitura Next Generation Forum] Transcend - v10 & v11 shared on same box
You were sent this message automatically by www.tessituranetwork.com because you subscribed to the Tessitura Next Generation forum email notifications. You may reply to this message or visit the site to reply to the post above. If replying via email, please consider deleting the previous message text before sending to help with readability on the site. Thank you!