Transcend - v10 & v11 shared on same box

I have Test instances for v10 & v11 side-by-side on the same box.  I also have Test Transcend on the same box which always worked fine with v10.  Now the Transcend ascii gateway in the Transcend control tray will not start.  I suspect this is a port conflict since I installed v11 services on this box.  Does this sound right?  I don’t recall setting any port# during the v11 setup.  Can I share transcend while testing v10 & v11? 

You were sent this message automatically by www.tessituranetwork.com because you subscribed to the Tessitura Next Generation forum email notifications. You may reply to this message or visit the site to reply to the post above. If replying via email, please consider deleting the previous message text before sending to help with readability on the site. Thank you!

I have Test instances for v10 & v11 side-by-side on the same box.  I also have Test Transcend on the same box which always worked fine with v10.  Now the Transcend ascii gateway in the Transcend control tray will not start.  I suspect this is a port conflict since I installed v11 services on this box.  Does this sound right?  I don’t recall setting any port# during the v11 setup.  Can I share transcend while testing v10 & v11? 

You were sent this message automatically by www.tessituranetwork.com because you subscribed to the Tessitura Next Generation forum email notifications. You may reply to this message or visit the site to reply to the post above. If replying via email, please consider deleting the previous message text before sending to help with readability on the site. Thank you!