Death and Syntaxes

Hi Matt

I think it don’t like you giving it a parameter that isn’t a value.  You can pass it a variable as below – that works

declare @pdate as datetime

select @pdate = dateadd(day,-1,convert(varchar,getdate(),112))

exec AP_MEMBERSHIP_UPDATE @i_memb_org = 1, @start_dt = '2005-09-01 00:00:00.000', @end_dt = @pdate

Moira

Fellow Tessiturians,

My Membership Update Opera job dies whenever it tries to run due to "Incorrect syntax near 'day'".  The command for the job is as follows:

AP_MEMBERSHIP_UPDATE @i_memb_org = 1, @start_dt = '2005-09-01 00:00:00.000', @end_dt = dateadd(day,-1,convert(varchar,getdate(),112))

Any ideas?  Everything seems correct, but apparently...not?

Thank you for your assistance.

Obligatory Trivia Biscuit:  Just 1,000 words make up 90% of all writing.

This message was sent automatically to you by www.tessituranetwork.com because you subscribed to the Tessitura Technical Forum. You may reply to this message to post to the Technical forum or visit the site to search, read and post to the forums. In the interest of keeping the forum posts from becoming cluttered, we encourage you to delete previous message text from your reply before sending. Thank you!

Hi Matt

I think it don’t like you giving it a parameter that isn’t a value.  You can pass it a variable as below – that works

declare @pdate as datetime

select @pdate = dateadd(day,-1,convert(varchar,getdate(),112))

exec AP_MEMBERSHIP_UPDATE @i_memb_org = 1, @start_dt = '2005-09-01 00:00:00.000', @end_dt = @pdate

Moira

Fellow Tessiturians,

My Membership Update Opera job dies whenever it tries to run due to "Incorrect syntax near 'day'".  The command for the job is as follows:

AP_MEMBERSHIP_UPDATE @i_memb_org = 1, @start_dt = '2005-09-01 00:00:00.000', @end_dt = dateadd(day,-1,convert(varchar,getdate(),112))

Any ideas?  Everything seems correct, but apparently...not?

Thank you for your assistance.

Obligatory Trivia Biscuit:  Just 1,000 words make up 90% of all writing.

This message was sent automatically to you by www.tessituranetwork.com because you subscribed to the Tessitura Technical Forum. You may reply to this message to post to the Technical forum or visit the site to search, read and post to the forums. In the interest of keeping the forum posts from becoming cluttered, we encourage you to delete previous message text from your reply before sending. Thank you!